Sealing strip chassis 5mm

Soft sealing strip that is located between the lower and upper chassis halves on the smaller machines.

This sealing strip is good to have at home if you want to check the condition inside the machine or do a service. It shall always be changed if you open up the machine.

Note! on these machines there are two sealing strips if you unscrew the chassis halves. A seal around the outer edge and a shorter one around the cutting motor in the center of the machine. If you want to remove the display, there is also a short sealing strip there.

The seal is recommended to be replaced when:

• Repair of wheel motors (if they cannot be pulled out far enough)
• Battery replacement
• Replacement of the front wheel lock washers above the front wheel axles or their bearings
• Replacement of the front joystick rubber boots
• Etc.

I always change these lock washers when I open a machine, because after 2014 they became galvanized instead of stainless. It often happens that the starlock lock washers crack so that the robot drops its front wheels.

The seal is installed with an overlap of approx. 15mm, just to be safe, check how the seal is fitted before you remove the old one.

Fits:
Husqvarna Automower 310 315 315X Not suitable for Mark II
Gardena Sileno 1000 1300 1600 2000